For sliding doors & windows
Locks in closed or vented position
Hardened steel pin locks into retaining ring
Easy to install
For interior or exterior use
Rotating bolt to prevent sawing
Key Blank: Briggs & Stratton B1 & Yale Blank Y13
Finish: Polished Brass
Mounts onto the edge of the upper window
Sliding stud stops opening at desired location
Flips away to allow window to open
Allows ventilation but prevents entry
Easy to install
1. Open window to desired height (not more than 4″ to 6″)
2. Position lock on inside edge of upper window as shown. Mark hole centers and drill small pilot holes. Install lock with screws provided.
3. Slide spring-loaded contact around to inside (closed) position.
4. Raise lower window (or lower upper window) observing where contact hits lower window frame. Mark center of that point. Install furnished strike plate.
Cam action lock
Locks windows in closed or vented position
1. Place lock on track against window frame.
2. Press down on lever to lock.
3. For loose fitting doors, it may be necessary to place lock inside top track. Press on lever to lock.
Mounts on vertical track
1. Close window and attach lock three to four inches above top of lower sash with nails enclosed.
2. Swing stop closed to engage window stop, preventing window from being raised past window stop.
For sliding door opening 28″- 52″
Telescoping aluminum locking bar
No cutting needed
To install inside sliding door:
1. Place rotating bracket on wall next to stationary door.
2. Mark and drill 1/8″ diameter holes and attach bracket to wall with screws provided.
3. With other end of bar in locking saddle, extend bar to inside edge of sliding door. Hold in horizontal position and mark and drill 1/8″ holes. Install screws through saddle catch into door.
To install outside sliding door:
1. Install jamb and bracket against inside edge of non-moving door.
2. Locking saddle install on inside frame of moveable door. Caution: Care must be taken that locking saddle is positioned at least 2″ above the sliding door handle.