$3.09
SKU: 1418
Finish: Polished Brass
Mounts on vertical track
Locks in closed or vented position
Flips away to allow window to open
Instructions:
1. Close window and attach lock 3″ to 4″ above top of lower sash with nails enclosed.
2. Swing stop closed to engage window stop, preventing window from being raised past window stop.
In stock
Add to Compare
SKU: 1427, 1427-10B
Finishes: Polished Brass & Oil Rubbed Bronze
Cam action provides tight closure
For aluminum, vinyl, or wood double hung
windows
Secondary lever must be activated to
allow opening
$4.59 – $4.69
SKU: 1404
Finish: White
For wood, aluminum, & vinyl double hung windows
Locks & unlocks with key
Cam action draws windows together to prevent drafts
Key Blank: Briggs & Stratton B1 & Yale Blank Y13
$10.09
SKU: 1430
Finish: Polished Brass
Mounts onto the edge of the upper window
Sliding stud stops opening at desired location
Flips away to allow window to open
Allows ventilation but prevents entry
Easy to install
Instructions:
1. Open window to desired height (not more than 4″ to 6″)
2. Position lock on inside edge of upper window as shown. Mark hole centers and drill small pilot holes. Install lock with screws provided.
3. Slide spring-loaded contact around to inside (closed) position.
4. Raise lower window (or lower upper window) observing where contact hits lower window frame. Mark center of that point. Install furnished strike plate.
$3.19
SKU: 1253
Finish: Aluminum Tone
Securely locks in closed or vented position
Assembled with hardened steel bolt
Easily activated with foot
Locks and unlocks with key
Key Blank: Briggs & Stratton B1 & Yale Blank Y13
Instructions:
CAUTION: Before installation, check with patio door manufacturer for door specifications. Failure to do so may result in glass breakage!
1. Close sliding door completely.
2. With bolt retracted, place lock in desired position at top or bottom of leading edge of sliding door, leaving enough room to clear track so door slides smoothly.
3. Tap back of lock lightly with hammer to mark bolt hole position; remove lock. Make sure drill will clear glass. Drill 1-1/32″ diameter hole for locking bolt.
4. With bolt extended, position lock and slide bolt into hole. mark screw holes, remove lock and drill 1/8″ diameter holes.
5. Replace lock; install with standard screws and tighten. Or, to make door tamper-proof, remove standard screws and replace with non-removable screws.
$10.59
SKU: 1970
Finish: Aluminum
For sliding doors & windows
Locks in closed or vented position
Hardened steel pin locks into retaining ring
Easy to install
$2.99
