$3.19
SKU: 1430
Finish: Polished Brass
Mounts onto the edge of the upper window
Sliding stud stops opening at desired location
Flips away to allow window to open
Allows ventilation but prevents entry
Easy to install
Instructions:
1. Open window to desired height (not more than 4″ to 6″)
2. Position lock on inside edge of upper window as shown. Mark hole centers and drill small pilot holes. Install lock with screws provided.
3. Slide spring-loaded contact around to inside (closed) position.
4. Raise lower window (or lower upper window) observing where contact hits lower window frame. Mark center of that point. Install furnished strike plate.
In stock
Add to Compare
SKU: 1253-W
Finish: White
Securely locks in closed or vented
position
Assembled with hardened steel bolt
Easily activated with foot
Locks/unlocks with key
Key Blank: Briggs & Stratton B1 & Yale Blank Y13
$10.53
SKU: 1251
Finish: Aluminum Tone
Securely locks in closed or vented
position
Assembled with hardened steel bolt
Easily activated with foot
$5.69
SKU: 1253-604
Finish: Aluminum Tone
Securely locks in closed or vented
position
Assembled with hardened steel bolt
Easily activated with foot
Locks/unlocks with key
Key Blank: Briggs & Stratton B1 & Yale Blank Y13
$10.59
SKU: 1432
Finish: Polished Brass
Rim mortise & surface strikes included
3 different keepers for special mounting
applications
For use on old style casement windows
Instructions:
Rim Strike Installation:
1. Place fastener in desired location and secure loosely with four screws.
2. Place rim strike in position to line up with fastener and install with two screws.
3. Check operation of fastener with strike and tighten all screws.
Mortise Strike Installation:
1. Place fastener in desired location and secure loosely with four screws.
2. Place mortise strike in position to line up with fastener. Mark position of screw holes, strike, and mortise hole using 3/16″ diameter drill and mortise a 3/4″ deep recess. Install mortise strike with two screws.
3. Check operation of fastener with strike and tighten all screws.
Surface Strike Installation:
1. Place fastener in desired location and secure loosely with four screws.
2. Place surface strike in position to line up with two screws.
3. Check operation and tight all screws.
$6.29
SKU: 1411
Finish: White
Comes in pack of two
Locks window in closed or vented position
For use on sliding windows
Extruded aluminum with steel thumbscrew
Instructions:
To Lock:
1. Close window securely.
2. Plack lock against edge of sliding window on bottom track and tighten thumb screw.
To Vent:
1. Open sliding window 1-1/2″ to 2″. Place lock against edge of sliding window on bottom track and tighten thumb screw.
$3.09
