$8.09
SKU: 1358
Finish: Chrome
Keyed locking for maximum security
Requires 3/4″ mounting hole
For wood or metal door or drawer
2 washers for 90 or 180 degree rotation
Max drawer thickness 1/4″
Key Blank: Briggs & Stratton B1 & Yale Blank Y13
Proposition 65 Warning
SKU: 1385
Finishes: Stainless Steel & Vintage Bronze
Keyed locking for maximum security
Requires 3/4″ mounting hole
For wood or metal door or drawer
2 washers for 90 or 180 degree rotation
Max drawer thickness 3/4″
Key Blank: Briggs & Stratton B1 & Yale Blank Y13
$12.89 – $13.99
SKU: 1045
Finish: Polished Brass
1/4″ adjustment for tight fit of door to frame
Stops door rattle
Assures engagement of dead latch function
Residential or commercial frames
Dimensions: 1-1/4″ x 2-3/4″
Door Thickness: All
Instructions:
Before starting first check door thickness for proper template alignment and then follow installation instructions.
-If door thickness is 1-3/4″ place template frame 3/16″ from door jamb.
-If door thickness is 1-3/8″ place template on the door jamb.
Installation Instructions:
1. Remove old strike.
2. Center template with latch hole and tape in place.
3. Position new strike in place and mark two holes. Chisel out area behind strike if needed or a flush fit is desired.
4. Drill 1/8″ pilot holes 2″ deep. Adjust to fit door.
$6.89
SKU: 1306
Finish: Chrome
Chrome-plated steel
Ideal for cabinets & cases with sliding glass doors
Adjustable length for many alignments
Key Blank: Briggs & Stratton B1 & Yale Blank Y13
Instructions:
1. Slide outside door to open position. Place lock on inside door as shown and tighten screw. To avoid breaking glass, do not over-tighten.
2. Close sliding doors completely.
3. Slide lock over notched locking plate, fitting the flat side against outside door edge.
$7.59
SKU: 1281
Finish: Polished Brass
Keyed locking for maximum security
Requires 3/4″ mounting hole
For wood or metal door or drawer
2 washers for 90 or 180 degree rotation
Max drawer thickness 3/4″
Key Blank: Briggs & Stratton B1 & Yale Blank Y13
$11.39
SKU: 1005
Finish: Polished Brass
Fits standard size doors
Mortising required
Screws at base of box strike secure to
2″ x 4″ framing for added security
Dimensions: 1-1/4″ x 4-7/8″
Door Thickness: All
Instructions:
1. Mark center of bolt on frame.
2. Cut out template (see insert), locate center mark on template with center mark on frame. Tape in place.
3. Draw around outside of template. Mark 4 holes through template. Drill 1″ holes per template.
4. Chisel out between 1″ holes and fit strike box.
5. Chisel out 1/8″ deep for strike.
6. Install strike and faceplate with top and bottom screws. (Be sure 2 holes in strike box are toward center of frame.)
7. Drill two 1/8″ pilot holes at bottom of strike box toward center of frame and install screws at an angle.
$8.49
