$5.69
SKU: 1251
Finish: Aluminum Tone
Securely locks in closed or vented
position
Assembled with hardened steel bolt
Easily activated with foot
Proposition 65 WarningIn stock
Add to Compare
SKU: 1253-W
Finish: White
Securely locks in closed or vented
position
Assembled with hardened steel bolt
Easily activated with foot
Locks/unlocks with key
Key Blank: Briggs & Stratton B1 & Yale Blank Y13
$10.53
SKU: 1430
Finish: Polished Brass
Mounts onto the edge of the upper window
Sliding stud stops opening at desired location
Flips away to allow window to open
Allows ventilation but prevents entry
Easy to install
Instructions:
1. Open window to desired height (not more than 4″ to 6″)
2. Position lock on inside edge of upper window as shown. Mark hole centers and drill small pilot holes. Install lock with screws provided.
3. Slide spring-loaded contact around to inside (closed) position.
4. Raise lower window (or lower upper window) observing where contact hits lower window frame. Mark center of that point. Install furnished strike plate.
$3.19
SKU: 1411
Finish: White
Comes in pack of two
Locks window in closed or vented position
For use on sliding windows
Extruded aluminum with steel thumbscrew
Instructions:
To Lock:
1. Close window securely.
2. Plack lock against edge of sliding window on bottom track and tighten thumb screw.
To Vent:
1. Open sliding window 1-1/2″ to 2″. Place lock against edge of sliding window on bottom track and tighten thumb screw.
$3.09
SKU: 1408
Finish: Aluminum
Extruded aluminum with no-mar vinyl inserts to protect track
Locks window in closed or vented position
Fits wide & narrow type tracks
For use on sliding windows
Instructions:
To Lock:
1. Close window securely.
2. Placke lock against edge of sliding window on bottom track and turn wing clockwise until wedge is tight.
To Vent:
1. Open sliding window 1-1/2″ to 2″. Place lock against edge of sliding window on bottom track and turn wing nut clockwise until wedge is tight.
$3.09 – $4.79
SKU: 1185
Finish: Aluminum
Locks window or door in closed or vented position
For use on sliding windows or sliding
doors
Extruded aluminum with two steel
thumbscrews
Instructions:
To Lock:
1. Close window securely.
2. Plack lock against edge of sliding window on bottom track and tighten thumb screw.
To Vent:
1. Open sliding window 1-1/2″ to 2″. Place lock against edge of sliding window on bottom track and tighten thumb screw.
$2.59
